Dungeon Tiles

[flyenemu]

Hi Mate, all the tiles are being done at 100ppi with the grid at the same scale, so yes, for use with standard mini's.

Re doors and other assets; Doors, my intention was to leave a 3ft gap for single doors and a 6ft gap for double doors (900mm & 1800mm for metric folk) and I was thinking GM's could either draw on the tiles (once laminated of course) or they could download them; Bogie & Torstan (aka Jonathon Roberts) here on the guild and numerous other have assets available for download, just Google Dundjinni xxxx where xxx is what you're looking for, so I wasn't really going to do them, I suppose in the interest of offering a complete package, I could make up some wooden, stone and particularly blank wall tiles.

Damonjynx,

I am glad to hear you have already thought about the grid size and how it will fit with standard minis! That will make your project even more DM friendly. As I stated in the Flagstone thread, I think the space for doors rather than including them pre-planted is very wise, and will allow DMs to better control what they are building from the random tables. Furthermore, there are several minis for tables, chairs, chests, etc. and there is no need to include them in your set. When I have time I will have to look at your google docs to give you better feedback on that.

Welcome to the party AdventureDepot. This is what I'm aiming for. I've started re-doing them in A0, so I can have multiple assets per page. Then I'll select each asset (using paths), copy them, with & without grid to a new PS document exactly the size of the asset, and save them as jpeg's in separate folders; Starting Areas, Passages & Chambers. Then, once I have all the assets, I'll combine them into a PDF document using Indesign and load them up to the DM Guild... a bit of work but it only took me a half an hour at lunch today to do the basic floor plan of each starting area. I'm making an assumption that all passages exiting a starting area are 10ft and all doors are double. The chambers & passages will take the most work as there are so many possible combinations of doors and passages widths...I don't think it would be possible to cover every possible combination but I'll do a few variants of each.

Below is a WIP of the starting areas.

My only concern regarding this phase of your project is the assumption that all visible exits from the entry room are 10’ wide. I understand why it is you went with this, and my only counter is in regards to the possibility of rolling a door or pathway to the contrary. However, I find it to be a very small problem, as I prefer all major exits from the entry to be 10’, with storage rooms and secret passages as the only exception. Keep up the beautiful work!! 